Instructions for installation:

1. Untie the green strings.
2. Hold posts and drop out the fence.
3. Start by inserting the post with the green strings into the ground at your starting point.
4. Tie this post to a stronger post. (Do not allow any metal to touch the electric twines.)
5. Pick up the remaining posts and walk across the field, releasing each post in turn.
6. At the end, pull the last post to tension the fence and insert the post.
7. Walk along the fence and push in all remaining posts.

To dismantle the fence:

1. Untie the green strings on the posts.
2. Lift each post as you walk down the line.
3. The fence will fold into loops as you proceed.
4. Lay the fence flat on the ground and ROLL the LOOSE ENDS to the POSTS.
   This ensures that the posts and strings are always on the outside ready for reuse.

To join rolls for continuity:

1. Untie the next roll of fence.
2. Using the post with the strings, insert it beside the last post of the previous roll and tie together.
   Be sure to connect the aluminum connectors.
3. Continue as in previous instructions.
4. Any post can be used as a corner post.
   Simply attach the guy line and peg for all directional changes.
5. The entire fence must be erected.
   Any surplus must be doubled back along itself.
6. Your fence charger should be put in the middle of a run of nets.
7. Connect the power lead to the aluminum clip.
8. Be sure the unit has a good ground rod installed.
9. ALWAYS keep the fence well ELECTRIFIED.

Tips:

• When not in use, store on a wall or beam to prevent vermin from nesting in the rolls.
• Up to 15 rolls can be run from a high power charger.
• No more than 5 rolls should be run from small battery powered chargers.