Subtotal $0.00
Resources
Fixed Knot Woven Wire Installation Photos
Augering post holes | |
Measuring correct post depth | |
Using a Tamp to tamp (compact) all dirt around the post. Put in a little at a time. | |
Installing brace pin into the horizontal brace post. | |
Stringing brace wire into a figure 8. | |
Showing finished brace wire with tensioner. | |
Tool used to tighten tensioner. | |
Staples being installed to hold the woven wire in place. | |
Tying off ends on the woven wire. | |
Installing the wedges in slots to hold wire when stretching. | |
Driving the wedges to hold the wire tight. | |
Crimping sleeves are used to splice in the middle of a run. | |
Chain walkers are used with the clamp to stretch the wire. | |
Wire is being pulled up. | |
Wire is now pulled up and ready to finish. | |
Wire is being pulled to tighten. | |
Putting the finish touch of tension on the wire. | |
Staples are placed to fasten the woven wire to the post. |